Header logo is


2015


no image
Human Machine Interface for Dexto Eka: - The humanoid robot

Kumra, S., Mohan, M., Gupta, S., Vaswani, H.

In Proceedings of the IEEE International Conference on Robotics, Automation, Control and Embedded Systems (RACE), Chennai, India, Febuary 2015 (inproceedings)

Abstract
This paper illustrates hybrid control system of the humanoid robot, Dexto:Eka: focusing on the dependent or slave mode. Efficiency of any system depends on the fluid operation of its control system. Here, we elucidate the control of 12 DoF robotic arms and an omnidirectional mecanum wheel drive using an exo-frame, and a Graphical User Interface (GUI) and a control column. This paper comprises of algorithms, control mechanisms and overall flow of execution for the regulation of robotic arms, graphical user interface and locomotion.

hi

DOI [BibTex]

2015


DOI [BibTex]


no image
Conception and development of Dexto:Eka: The Humanoid Robot - Part IV

Kumra, S., Mohan, M., Vaswani, H., Gupta, S.

In Proceedings of the IEEE International Conference on Robotics, Automation, Control and Embedded Systems (RACE), Febuary 2015 (inproceedings)

Abstract
This paper elucidates the fourth phase of the development of `Dexto:Eka: - The Humanoid Robot'. It lays special emphasis on the conception of the locomotion drive and the development of vision based system that aids navigation and tele-operation. The first three phases terminated with the completion of two robotic arms with six degrees of freedom each, structural development and the creation of a human machine interface that included an exo-frame, a control column and a graphical user interface. This phase also involved the enhancement of the exo-frame to a vision based system using a Kinect camera. The paper also focuses on the reasons behind choosing the locomotion drive and the benefits it has.

hi

DOI [BibTex]

DOI [BibTex]


no image
Trajectory generation for multi-contact momentum control

Herzog, A., Rotella, N., Schaal, S., Righetti, L.

In 2015 IEEE-RAS 15th International Conference on Humanoid Robots (Humanoids), pages: 874-880, IEEE, Seoul, South Korea, 2015 (inproceedings)

Abstract
Simplified models of the dynamics such as the linear inverted pendulum model (LIPM) have proven to perform well for biped walking on flat ground. However, for more complex tasks the assumptions of these models can become limiting. For example, the LIPM does not allow for the control of contact forces independently, is limited to co-planar contacts and assumes that the angular momentum is zero. In this paper, we propose to use the full momentum equations of a humanoid robot in a trajectory optimization framework to plan its center of mass, linear and angular momentum trajectories. The model also allows for planning desired contact forces for each end-effector in arbitrary contact locations. We extend our previous results on linear quadratic regulator (LQR) design for momentum control by computing the (linearized) optimal momentum feedback law in a receding horizon fashion. The resulting desired momentum and the associated feedback law are then used in a hierarchical whole body control approach. Simulation experiments show that the approach is computationally fast and is able to generate plans for locomotion on complex terrains while demonstrating good tracking performance for the full humanoid control.

am mg

link (url) DOI [BibTex]

link (url) DOI [BibTex]


no image
Humanoid Momentum Estimation Using Sensed Contact Wrenches

Rotella, N., Herzog, A., Schaal, S., Righetti, L.

In 2015 IEEE-RAS 15th International Conference on Humanoid Robots (Humanoids), pages: 556-563, IEEE, Seoul, South Korea, 2015 (inproceedings)

Abstract
This work presents approaches for the estimation of quantities important for the control of the momentum of a humanoid robot. In contrast to previous approaches which use simplified models such as the Linear Inverted Pendulum Model, we present estimators based on the momentum dynamics of the robot. By using this simple yet dynamically-consistent model, we avoid the issues of using simplified models for estimation. We develop an estimator for the center of mass and full momentum which can be reformulated to estimate center of mass offsets as well as external wrenches applied to the robot. The observability of these estimators is investigated and their performance is evaluated in comparison to previous approaches.

am mg

link (url) DOI [BibTex]

link (url) DOI [BibTex]

2007


no image
Single lamella crystals of polyethylene accessible by catalytic emulsion-polymerization

Weber, C. H. M., Chiche, A., Krausch, G., Rosenfeldt, S., Ballauff, M., Goettker-Schnetmann, I., Tong, Q., Mecking, S., Harnau, L.

In Polymeric Materials: Science \& Engineering, 97, pages: 133-134, 2007 (inproceedings)

icm

[BibTex]

2007


[BibTex]


no image
Hand placement during quadruped locomotion in a humanoid robot: A dynamical system approach

Degallier, S., Righetti, L., Ijspeert, A.

In 2007 IEEE/RSJ International Conference on Intelligent Robots and Systems, pages: 2047-2052, IEEE, San Diego, USA, 2007 (inproceedings)

Abstract
Locomotion on an irregular surface is a challenging task in robotics. Among different problems to solve to obtain robust locomotion, visually guided locomotion and accurate foot placement are of crucial importance. Robust controllers able to adapt to sensory-motor feedbacks, in particular to properly place feet on specific locations, are thus needed. Dynamical systems are well suited for this task as any online modification of the parameters leads to a smooth adaptation of the trajectories, allowing a safe integration of sensory-motor feedback. In this contribution, as a first step in the direction of locomotion on irregular surfaces, we present a controller that allows hand placement during crawling in a simulated humanoid robot. The goal of the controller is to superimpose rhythmic movements for crawling with discrete (i.e. short-term) modulations of the hand placements to reach specific marks on the ground.

mg

link (url) DOI [BibTex]

link (url) DOI [BibTex]


no image
Lower body realization of the baby humanoid - ‘iCub’

Tsagarakis, N., Becchi, F., Righetti, L., Ijspeert, A., Caldwell, D.

In 2007 IEEE/RSJ International Conference on Intelligent Robots and Systems, pages: 3616-3622, IEEE, San Diego, USA, 2007 (inproceedings)

Abstract
Nowadays, the understanding of the human cognition and it application to robotic systems forms a great challenge of research. The iCub is a robotic platform that was developed within the RobotCub European project to provide the cognition research community with an open baby- humanoid platform for understanding and development of cognitive systems. In this paper we present the design requirements and mechanical realization of the lower body developed for the "iCub". In particular the leg and the waist mechanisms adopted for lower body to match the size and physical abilities of a 2 frac12 year old human baby are introduced.

mg

link (url) DOI [BibTex]

link (url) DOI [BibTex]

2006


no image
Slow dynamics at critical points: the field-theoretical perspective

Gambassi, A.

In Journal of Physics: Conference Series, 40, pages: 13-26, Luxembourg City [Luxembourg], 2006 (inproceedings)

icm

DOI [BibTex]

2006


DOI [BibTex]


no image
Movement generation using dynamical systems : a humanoid robot performing a drumming task

Degallier, S., Santos, C. P., Righetti, L., Ijspeert, A.

In 2006 6th IEEE-RAS International Conference on Humanoid Robots, pages: 512-517, IEEE, Genova, Italy, 2006 (inproceedings)

Abstract
The online generation of trajectories in humanoid robots remains a difficult problem. In this contribution, we present a system that allows the superposition, and the switch between, discrete and rhythmic movements. Our approach uses nonlinear dynamical systems for generating trajectories online and in real time. Our goal is to make use of attractor properties of dynamical systems in order to provide robustness against small perturbations and to enable online modulation of the trajectories. The system is demonstrated on a humanoid robot performing a drumming task.

mg

link (url) DOI [BibTex]

link (url) DOI [BibTex]


no image
Design methodologies for central pattern generators: an application to crawling humanoids

Righetti, L., Ijspeert, A.

In Proceedings of Robotics: Science and Systems, Philadelphia, USA, August 2006 (inproceedings)

mg

link (url) DOI [BibTex]

link (url) DOI [BibTex]


no image
Programmable central pattern generators: an application to biped locomotion control

Righetti, L., Ijspeert, A.

In Proceedings of the IEEE International Conference on Robotics and Automation, 2006. ICRA 2006., pages: 1585-1590, IEEE, 2006 (inproceedings)

mg

[BibTex]

[BibTex]

2002


no image
Nucleons as relativistic three-quark states

Oettel, M.

In Proceedings of the Workshop on Physics at the Japan Hadron Facility (JHF), pages: 203-211, World Scientific, Adelaide, Australia, 2002 (inproceedings)

icm

[BibTex]

2002


[BibTex]


no image
Capture-Numbers and Island Size-Distributions in Irreversible Homoepitaxial Growth: A Rate-Equation Approach

Popescu, M. N., Family, F., Amar, J. G.

In Atomistic Aspects of Epitaxial Growth, pages: 99-110, NATO Science Series: Series 2, Mathematics, Physics, and Chemistry, Kluwer Academic Publishers, Dassia [Korfu, Greece], 2002 (inproceedings)

icm

[BibTex]

[BibTex]


no image
Non-Gaussian morphology of galaxy-cluster distribution: Minkowski functionals of the REFLEX catalogue

Kerscher, M., Mecke, K., Schücker, P., Reflex Collaboration

In Tracing Cosmic Evolution with Galaxy Clusters. Proceedings of the Sesto-2001 Workshop, 268, pages: 60-62, Astronomical Society Pacific Conference Series, Alto Adige/Südtirol, 2002 (inproceedings)

icm

[BibTex]

[BibTex]

2001


no image
Diffusion of implanted 195Au radiotracer atoms in amorphous silicon under irradiation with 1 MeV-N+ ions

Voss, T., Scharwaechter, P., Frank, W.

In Proceedings of DIMAT 2000, the Fifth International Conference on Diffusion in Materials, 194/199, pages: 659-665, Defect and Diffusion Forum, Scitec Publications Ltd., Paris, France, 2001 (inproceedings)

icm

[BibTex]

2001


[BibTex]


no image
Diffusion of gold in the amorphous ceramic Si28C36N36

Matics, S., Frank, W.

In Proceedings of DIMAT 2000, the Fifth International Conference on Diffusion in Materials, 194/199, pages: 947-952, Diffusion and Defect Forum, Scitec Publications Ltd., Paris, France, 2001 (inproceedings)

icm

[BibTex]

[BibTex]


no image
Diffusion of gold in germanium

Strohm, A., Matics, S., Frank, W.

In Proceedings of DIMAT 2000, the Fifth International Conference on Diffusion in Materials, 194/199, pages: 629-634, Defect and Diffusion Forum, Scitech Publ. Ltd., Paris, France, 2001 (inproceedings)

icm

[BibTex]

[BibTex]